Use Digitize > Digitize Blocks to digitize column shapes of varying width, setting the stitch angle at each pair of points.
|
|
Use Digitize > Digitize Blocks to digitize column shapes of varying width, setting the stitch angle at each pair of points. |
In addition to normal digitizing tools, the Digitize Blocks tool can be used with Satin to create turning fills of varying width.
Digitize the column by marking points on alternate sides of the column. Click to enter corner points. Right-click to enter curve points.
The control points in a pair do not have to be the same type. For example, one can be a corner point, the other a curve.
If you make a mistake, press Backspace to delete the last point. Press Esc to undo all new points. Press Esc again to exit digitizing mode.
When you have finished digitizing, either:
Press Enter to keep the last stitch and place the exit point at the last point you digitized, or
Press Spacebar to omit the last stitch and place the exit point on the opposite side of the column.
Modules complémentaires
Commencez et apprenez plus vite avec...
